• Gender: Female
• Age: 36
• Designation: Fresh/Entry Level
• Highest Education Level: Graduate - Degree
• Expected Gross Salary: INR  200000 /Annum
• Preferred Country: India
• Preferred Location: North-india
• Work Experience: 13.6 Year(s)

Education

B.Tech Graduate In Plastic Engineering From Central Institute Of Plastics Engineering and Technology. (Govt. of India) Bhubaneswar, Orissa. With CGPA 7.54 In 2008-2012
10+2 In Science From CHSE Board Orissa With 61% In 2004 - 2006
10th (Matriculation) From HSC, Orissa With 76% In 2004

Skill Sets

Skill in designing using Pro-E and Auto CAD, in R&D of polymeric materials, in machineries like injection molding, compression molding etc.

Work Experience

Project Work:
The aim of this work, with in the frame work of polymer recycling is to upgrade waste from electrical and electronic waste equipments. Blend of two major residues are prepared via a melt blending process. These are ABS consisting of a SAN thermoplastic matrix and PVC. The effect of partial miscibility and previous degradation levels was investigated. Mechanical characterization of ABS/PVC system is carried out to determine the optimum composition range. Previous degradation levels of two wastes are investigated by FTIR.

TRAINING & CONFERENCES:
In plant Training in “FORMULATED POLYMERS LIMITED”, Chennai, in following areas:
UL 94- Flammability (HB, V-0, V-1, V-2, 5V, 5V-A, 5V-B, VTM-0, VTM-1, VTM-2) using flammability tester and the test methods used are-
1. IEC 60707 Ed. 2.0 b:1999, 2. IEC 60695-11-10, 3. ISO 9772, 4. ISO 9773
Limiting Oxygen Index (LOI) test, using test method ASTM D2863-09.
Smoke density test, using test method ASTM D2843-99 (2004).
Rate of burning test, using test method ASTM D635-06 & ASTM D1433-77.
Mechanical equipments like UTM, Impact tester, Motorized Notch cutter, Hardness tester
Thermal equipments like Dielectric tester
Electrical equipments like HDT Tester
Environmental equipments like QUV Weather-o-meter.
(b) APM-2010, International conference on Advancement in Polymeric Materials at CIPET, Bhu-baneswar.
(c) Design and manufacturing of hand injection mould of KEY RING done at CTTC (Central Tool Room and Training Center), Bhubaneswar.
(d) Participated and presented a project on the topic “STUDY ON EPOXY-SILICONE/ZnO THERMOLYTIC ADHESIVE FOR LED APPLICATION” in the New idea poster competition at Institute of Mineral and Materials Technology (IMMT), Bhubaneswar

Future Goals

To be a good engineer in the field of research and development.
To sustain and utilize as resource for all kind of challenging job by upgrading my knowledge & skill for time and grow with organization